Pump Mechanical Seal vs Gland Packing: Compare the Complete Sealing System
Compare pump mechanical seals and gland packing by leakage, liquid compatibility, maintenance, support requirements and lifecycle cost before choosing an arrangement.
Newsroom
Nachrichten & Projektgeschichten
Aktuelle Neuigkeiten von Borra zu Produktlieferungen, technischen Anwendungen und Projektgeschichten aus dem Markt.
Pump Vibration Measurement: Build a Repeatable Route Before Diagnosing Faults
Pump vibration measurement is useful when the sensor location, direction, mounting method, instrument settings and operating condition are recorded consistently. A number taken from an arbitrary point on the casing cannot reliably identify a bearing defect or prove that a pump meets an acceptance standard. Establish an approved measurement route, collect a baseline at a known duty, and compare like with like before choosing corrective work. This guide covers planning and documenting measurements on industrial water-pump installations. It does not supply a...
Pump Baseplate Grouting: An Inspection Plan from Preparation to Handover
Plan pump baseplate grouting inspections, from design and material approval to surface preparation, placement, curing and final mechanical handover.
Centrifugal Pump Air Binding: Find the Air Source Before Restarting
Identify centrifugal pump air binding, separate air entry from vapor cavitation, inspect suction sources, and verify a safe recovery before restarting.
Centrifugal Pump Impeller Trimming: When to Consider It and What to Verify
Centrifugal pump impeller trimming is a manufacturer-controlled reduction of an impeller's outside diameter to change the pump's performance. It can be useful when an installed pump consistently provides more head than a reasonably stable duty requires. It is not a universal repair for poor performance, and it should not be specified from a guessed diameter ratio. Confirm the real system requirement, obtain a supplier-approved trimmed curve, and review efficiency, operating range, suction conditions, mechanical suitability, and the complete cost before authorising any...
Centrifugal Pump Runout: Diagnose Excess Flow and Low System Resistance
Centrifugal pump runout describes operation toward the high-flow end of a pump curve, where the installation can push the pump beyond its approved operating range. It is different from mechanical shaft runout, which concerns geometric deviation of a rotating part. Diagnose hydraulic runout by measuring the actual flow, head, speed, and suction condition, then comparing the operating point with the correct manufacturer's curve and limits. A low discharge-pressure reading alone does not prove runout, and an apparently healthy motor current does not...
Berechnung der Pumpenleistung: Hydraulische Leistung, Wellenleistung und Motorleistung
Berechnen Sie die hydraulische Leistung, die Wellenleistung und die elektrische Leistung einer Zentrifugalpumpe in konsistenten SI-Einheiten, mit einer Wirkungsgradberechnung und anhand eines beispielhaften Beispiels.
Pumpen in Serie vs. Parallel: Kurvenvergleiche vor der Kapazitätssteigerung
Vergleichen Sie Pumpen in Serie und Parallel anhand kombinierter Kurven, Systemwiderstand, Saugbedingungen, Druckgrenzen und Betriebskombinationen.